ComNav SinoGNSS T300 - Reset Grid Function

SinoGNSS
○
R
T300 User Guide
39
6.6.2 Reset Grid Function
Grid Reset function is applied when you need to change the position of base station
in the same project. The following example shows that reset point 2 based on point
1 (known point).
4. After adding all the points in the
list, click Cal button, the software
will calibrate all the points
inputted (ensure Max H.Resid <
0.015m, Max V.Resid < 0.02m).
5. Click OK to complete site
calibration.