Compaq 1000 Series

Index 3
configuration parameters
explained 4-4
specifying audio alarm 4-4
nominal utility voltage level
related configuration
parameters 4-4
nominal utility voltage range
related configuration
parameters 4-4
overview 4-1
parameters 4-3
Reset Defaults, restoring 4-5
Shutdown Delay
enabling 3-minute 4-4
enabling 5-second 4-4
Sleep mode
disabling 4-5
enabling 4-5
warning about pressing
STANDBY 4-2, 4-6
Wiring Fault audio alarm
disabling 4-4
enabling 4-4
Configure mode
exiting 4-7
explained 3-2
initiating 3-3
connecting
devices to UPS 2-10
Network Transient
Protector 2-6
Remote Emergency Power
Off 2-7
serial communications
cable 2-5
UPS to utility power 2-9
UPS/computer interface
cable 2-5
converting Watts to VA 2-10
D
Declaration of Conformity A-2
disposing of used batteries 5-13
E
environmental specifications C-9
European Union Notice A-4
F
FailSafe III
cabling requirement 2-5
overview 1-7
features
communications port 1-7
Compaq Multi-Server UPS
Card 1-8
Compaq Power Management
Software 1-7
Compaq Scalable UPS
card 1-9
Compaq SNMP-EN Internal
Adapter 1-9
FailSafe III 1-7
LanSafe III 1-7
Network Transient
Protector 1-10
Remote Emergency Power
Off 1-10
UPS 1000 Series 1-6
warranties 1-11
Federal Communications
Commission (FCC) notice A-1
cables A-3
FCC Class A compliance A-2
FCC Class B compliance A-2
modifications to
equipment A-3
front panel
AC Input LEDs,
explained 3-6
Battery Service LED,
explained 3-7
Communication LED,
explained 3-8
configuration
rack-mountable model,
illustrated 1-3
tower model, illustrated 1-3
indicating battery charge 5-12
LED display