. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6-6 Using Security Management
Writer: Project: Using Security Management Comments:
File Name: H-ch6.doc Last Saved On: 4/24/97 10:34 AM
Entering the Password
To enter the password, complete the following steps:
1. Turn on the computer.
2. When the Power-On password screen appears on the monitor, enter the
current password. For security, the characters you type do not appear
on the screen.
3. If you enter the power-on password incorrectly, the message “Password
Invalid” is displayed. Try again. After three unsuccessful tries, you
must turn the computer off and on again before you can continue.
The Power-On password entry screen appears only when the computer
is turned on. When you reset the computer using Ctrl+Alt+Del, you do
not have to enter the password. The new password takes effect the next
time you turn on the computer.
Changing the Password
To change the password, complete the following steps:
1. Turn on the computer.
2. When the Power-On password entry screen appears, enter
current/new/new
where current is the current password, new is the new password, and the
second new is a verification of the new password.
3. The new password takes effect the next time you turn on the computer.
To Next Page
Loading...
