Compaq ProLiant 800 - Placing the Battery

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A-3
Compaq ProLiant 800 Server Reference Guide
Writer: Project: Installing a New Battery Comments:
File Name: K-appa.doc Last Saved On: 4/24/97 10:45 AM
The following illustration identifies the header location for the new battery.
3. Change the jumper on header E2 from pins 6-7 to pins 5-6.
NOTE: When a jumper is on header E2 / pins 6-7, the internal battery is used.
When a jumper is on header E2 / pins 5-6, the external battery is used.
Figure A-1. Battery Jumpers on the System Board
Placing the Battery
1. Remove the backing from the adhesive on the hook-and-loop fastener
strip.
2. Place the battery and the hook-and-loop fastener strip on the chassis
floor, as shown in the following illustration.