. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6-7
Compaq ProLiant 800 Server Reference Guide
Writer: Project: Using Security Management Comments:
File Name: H-ch6.doc Last Saved On: 4/24/97 10:34 AM
Deleting the Password
1. Turn on the computer.
2. When the Power-On password entry screen appears, enter
current/
where current is the current password.
3. The password is now deleted until you establish a new password
through the System Configuration Utility.
Clearing the Password
If you forget your Power-On or Administrator Password, you can clear all
passwords by turning off the computer and disabling the Power-On and
Administrator Password by placing switch 1 on the 8-position switch bank
(SW1) to the ON position. This switch change does not take effect until the
computer is turned on.
NOTE: Switch 1 must be OFF to reenable the Power-On and Administrator
Passwords.
To clear the Power-On and Administrator Passwords, follow these steps:
1. Turn off the server.
2. Remove the side access panel of the unit.
3. Place switch 1 on the 8-position switch bank (SW1) to the ON position.
4. Replace the side access panel of the unit and turn on the computer.
The Power-On and Administrator Passwords are now clear.
To Next Page
Loading...
