. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-14 Server Management
Writer: Project: Server Management Comments:
File Name: D-ch2.doc Last Saved On: 4/23/97 11:14 AM
Unattended Recovery
For unattended recovery, ASR-2 logs the error information to the Critical
Error Log, resets the server, pages you (if a modem is present and you
selected paging), and tries to restart the operating system. Often the server
restarts successfully, making unattended recovery the ideal choice for remote
locations where trained service personnel are not immediately available.
ASR-2 tries to restart the server up to 10 times. If ASR-2 cannot restart the
server within 10 attempts, it places a critical error in the Critical Error Log,
starts the server into Compaq Utilities, and enables remote access (if you
configured remote access).
To use this level of ASR-2, you must configure ASR-2 to load the operating
system after restart.
Attended Recovery
For attended recovery, ASR-2 takes the following actions:
Logs the error information to the Critical Error Log
Resets the server
Pages you (if a modem is present and you selected Paging)
Starts Compaq Utilities from the hard drive
Enables remote access
During system configuration, these utilities are placed on the system utilities
partition of the hard drive.
To Next Page
Loading...
