Compaq ProLiant 800 - Page 9

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
xii Introduction
Compaq ProLiant 800 Server Reference Guide
Writer: Project: Introduction Comments:
File Name: B-intro.doc Last Saved On: 4/22/97 4:06 PM
Chapter 8 −− Using Diagnostics Tools
This chapter describes software and firmware diagnostic tools available
for ProLiant 800 users.
Appendix A −− Installing a New Battery
This appendix contains information on replacing the I/O and Riser
Wide-Ultra SCSI controller batteries.
Appendix B −− Power Cord Set Requirements
This appendix contains requirements for the power cord set now
available with the Compaq ProLiant 800 servers. A table lists power
cord set requirements for each country.
Appendix C −− Electrostatic Discharge
This appendix suggests ways to prevent electrostatic discharge (ESD)
and the damage it can cause.
Appendix D −− Switches and Jumpers
This appendix provides the correct settings for the switches on the I/O
board and processor boards.
Appendix E −− Installing the Server
This appendix provides instructions for first-time server installation.
Appendix F −− Federal Communications Commission Notice
Index