-20-
3.23- TEST TARGET
Press
1
and display will show
When we see the submenu name, we have to
press the button
TEAM
to enter into this submenu, where we are able
to test the correct connection of all the target
segments to the foil matrix sensor in the
machine.When we press a sector, for example
double 15, we see
you can use the display board, where the
‘game’ display indicate if the sector is
single, double or triple by indicating 1, 2
and 3 respectively, while the correct sector
number is displayed on the ‘round’ display.
3.24- TEST LEDS
Press
1
and display will show
When we see the submenu name, we have to
press the button
TEAM
to enter into this submenu, where we are
able to test the correct lighting of all the
LEDS in the machine.
We change the test mode with the button
PLAYERS
and with
1
2
we move up and down between
where we test the led's one by one.
where the led's turn on by horizontal
lines.
where led seven segment displays turn
on display by display with all the segment
lighted.
Here the first segment 'a' is turned on in
all the displays, then segment 'b', and so
until segment 'g'.
All display board LED's are lit at same
time, including displays and leds ring on
target.
Once we are finished with all the tests, to
leave the submenu we have to press the
button
TEAM
3.25- ROUND HI-SCORE
PROGRAMMING 3.23- TEST TARGET
3.24- TEST LEDS
LED BY LED TEST
HORIZONTAL LINES
DIGIT UNITS
DIGIT SEGMENTS
ALL LED
To Next Page
Loading...