11.5 Speed monitor
The machine can as an option be equipped
with a speed monitor.
The speed monitor
is set at the factory
and does not normally
require re-adjustment.
The speed monitor triggers
and stops the granulator if
the rotor does not reach the
correct speed after starting,
or if the speed drops to a
level too low for granulating.
If the speed monitor triggers and stops the granulator:
Check that the drive belts do not slip.
The speed monitor has not reset.
Check that there is no material left in the
granulator before
re-starting.
Clean and re-start the granulator.
The sensors to the speed
monitor are placed on
the cutter belt pulley
Speed monitor relay
in electrical cabinet.
1 1
Options
Options l 11-9
To Next Page