6-2 l Operatio n and Daily Mainte nance
6.1 Start and stop
The main switch is located
on the electrical cabinet.
Starting and stopping is
controlled by push
buttons on the
control panel.
Start
• Open the doors.
– check that the granule bin is properly installed.
– check that the hopper is properly closed.
– check that the cutter house door is properly closed.
– check that the lock handle to the the cutter house door locks the cutter house
door properly.
– check that the socket cap screws inside the locking device are properly
tightened.
Hopper
Cutter house door
Granule bin
Lock handle
cutter house
door
Check the screws, hex wrench
22 mm.
First pull the lock handle out-
wards. Then lift the lock
handle upwards so that the
breaking key enters the safety
switch.
First pull the lock handle
outwards and then press the
lock handle down.
To Next Page
Loading...