5.5 Installation
Adjust the granulator stand
Set up the granulator in the place of use.
Adjust so that the granulator cutter
housing leveled horizontally.
Use a spirit level!
• Noise encapsulated machine open the doors.
• Open the door to the cutter housing. see section 5.5
• Open the hopper. see section 5.5
Open the hopper only sufficiently for the spirit level that you are using.
• Close the door to the cutter housing properly. see section 5.6
• Adjust the horizontal position of the cutter housing in depth and sideways.
Adjust the cutter housing using the machine shoes on the stand, use a spirit level.
Adjust so that the cutter housing is accurately in horizontal level.
IMPORTANT! Make sure that all of the machine shoes carry load.
• Open the door to the cutter housing. see section 5.5
• Close the hopper, see section 5.6
• Close the door to the cutter housing properly, see section 5.6
• Noise encapsulated machine close the doors.
NOTE: The distribution of weight may
not be altered when adjusting the
machine shoes.
NOTE: If the granulator cutter housing
is not accurately in horizontal level, it
may be difficult to open and close the
door to the cutter housing.
NOTE: Sign the executed
installation in the machine
maintenance schedule.
5-8 l Mainte nance
To Next Page
Loading...