Conair 1836 - Safety instructions and safety measures concerning the electrical system; Safety instructions and safety measures with regard to cleaning, maintenance and service

Security l 4-7
4
Security
• There must always be a gap between the scrapers and the feed rolls.
The scrapers must never have metallic contact with the feed rolls.
Safety instructions and safety measures concerning the electrical system
• Electrical installation must only be done by a competent electrician!
• The electrical cabinet of the machine contains hazardous high voltage.
• The electrical cabinet door must never be opened when the granulator is
in operation.
• Immediately after the granulator hopper is opened during service and
maintenance, break the power supply with the main switch on the
electrical cabinet. Then lock the knob to the main switch.
• Never insert fingers, hands or arms into openings of the granulator, if
not the knob to the main switch is in “Off” (0) position and locked.
• The key for the electrical cabinet is a safety component.
The key must be kept by the person who is responsible for granulator
safety, service and maintenance.
• Never change or modify the basic electrical settings of the granulator,
without first obtaining permission from Conair.
If the granulator settings are changed, the machine can be seriously
damaged.
All Warranties and Conair’s Product Liability will be void, if the basic
settings of the granulator are changed.
• All electrical maintenance and service work must be done by trained
and competent personnel.
Safety instructions and safety measures with regard to cleaning, maintenance
and service
• All service must be carried out by trained personnel in order to avoid
personal injury or damage to the machine.
• Never leave the granulator without supervision while the cutter lock is
released. Danger of personal injury and damage to the machine.
• WARNING! Granulate and plastic rests on the floor can cause risk of
slipping!
Risk of slipping depending of granulate and plastic rests, is especially
hazardous when the cutter house door is open, during cleaning,
maintenance and service.
• Always use protective goggles and protective gloves during cleaning,
maintenance and service.
•NOTE: When the cutter house door and the hopper have been opened
for service or maintenance, it is recommended that the cutter in the
granulator is covered by using a carpet.
This to avoid that any person can be injured in contact with the cutter.