78
• Move the TEST/NORMAL switch to the TEST position.
Press a control button on the temporary buttons and start the lift. The indicator will
illuminate showing a FUNCTION number. While the display is illuminated, press the
ONES and TENS buttons at the same time. The display will start to flash. Release
the buttons when the flashing starts.
• The processor is now in programming mode.
The settings are shown on the display as F0 through F6, with each FUNCTION (F)
requiring a different setting.
• F0 represents adjustment of the start time delay.
The start time delay is the amount of time between motor start up and lift motion; this
delay is usually only required on smaller lifts such as the KWIKLIFT. Adjust the
numbers higher to increase the start time delay and downwards to reduce the start
time delay.
• F1 represents UP acceleration and UP deceleration.
Setting to a higher number shortens or makes the acceleration or deceleration
harsher; setting to a lower number lengthens or softens the acceleration or
deceleration.
• F2 represents UP leveling speed.
Setting to a higher number increases the leveling speed; setting to a lower number
decreases the leveling speed.
• F3 represents UP fast speed.
Setting to a higher number increases the full speed of the lift; setting to a lower
number decreases the full speed of the lift.
• F4 represents DOWN acceleration and deceleration.
Setting to a higher number shortens or makes the acceleration or deceleration
harsher; setting to a lower number lengthens or softens the acceleration or
deceleration.
• F5 represents DOWN leveling speed.
Setting to a higher number increases the leveling speed; setting to a lower number
decreases the leveling speed.
• F6 represents DOWN fast speed.
Setting to a higher number increases the full speed of the lift; setting to a lower
number decreases the full speed of the lift.
While in the test mode, in order to scroll through the “F” functions, press the ONES button on
the right side of the LED display. The left side of the display indicator shows an “F”. The right
side of the indicator shows the FUNCTION chosen, a number from 0 to 6. Choose the
FUNCTION number that you wish to review, for example F6, DOWN Full Speed. Press the
button slowly for each number increase or decrease.
This is the first adjustment setting. Scroll the ONES button until a “6” appears, and the entire
display will now show F6.
To Next Page
Loading...