Consilium CM2.2 - Introduction; About this Manual; References; Symbols Used in the Manual

User Manual 1Introduction
5100606_CFD5000 T - CM2.2_User Manual_T_EN_2023_E
1
1 Introduction
1.1 About this manual
This manual is intended for trained personnel using the CFD5000T fire detection
system and provides basic understanding how to operate the system.
NOTE!
This manual is valid for SW-version 2.2.10
Chapters User Instructions for Control Panel M 2.2, and describes how to operate
the fire detection system in case of a fire or fault alarm. Login and explanation for
all menu alternatives can be found here.
For brief instructions, see the Quick Guide for Control Panel M 2.2, page 11 and .
Lists of fault codes generated by loop units and system modules can be found in
chapter Fault codes.
For testing, please refer to the the Installation & Commissioning manual, 5100601.
1.2 References
The following technical product manuals are available for the CFD5000T fire
detection system:
5100606 CFD5000 T / CM2.2 User Manual
5100607 CFD5000 T / CM2.2 Installation & Commissioning Manual
5100608 CFD5000 T / CM2.2 Service & Maintenance Manual
5100609 CFD5000 T / CM2.2 Quick Guide
5100610 CFD5000 T / Application & Programming Manual
6302935 CFD5000 Safety Manual
6303933 CCP SIL - Safety Measures Checklist
1.3 Symbols used in the manual
DANGER!
Risk of serious or fatal injury to the user, and/or severe damage to the product, if the
instructions are not followed.
WARNING!
Risk of personal injury and/or damage to the product if the instructions are not
followed.
CAUTION!
Risk of minor or moderate personal injury. Risk of equipment damage, loss of data,
extra work, or unexpected results, if the instructions are not followed.