7. CONTEC Manager
28
Software Manual
Loading services
Show CONTEC Manager, select the “Service” tab.
There are 4 services to load, that is “FTP Server”, “Remote Control Server”, “Auto Run Function”, and
“NTP Time Adjust”.
FTP Server
To load “FTP Server” service, check the “Start FTP Server” check box.
If the “FTP Server” is started, the remote FTP client can access the Windows CE file system by FTP
protocol.
Remote Control Server
To load “Remote Control Server” service, check the “Start Remote Control Server” check box.
If the Remote Control Server Function is started, the “CONTEC Remote Manager” can control the
Windows CE device.
AutoRun Function
To load “AutoRun” service, check the “Start Auto Run Function” check box.
If the AutoRun Function is started, when an ATA card or Compact Flash Card is inserted into the card
slot, the AutoRun function will try to find the autorun.inf file in the card. If there exists an autorun.inf,
AutoRun will run programs set in the autorun.inf.
NTP Time Adjust
To load “NTP Time Adjust” service, check the “Start NTP Time Adjust” check box.
Designate a NTP server IP address in the “NTP Server IP” edit box.
Input time length in the “Adjust Time Every:” edit box in minutes. If “0” is selected, the NTP server will
be accessed only once at startup of CONTEC Manager.
If the NTP Time Adjust Function is started, the Windows CE device will acquire the current time from
the specified NTP server to set the system time.
To Next Page
Loading...
Need help?
General
