TABLE OF CONTENTS
DECLARATION OF CONFORMITY ....................................................................ii
CERTIFICATE OF COMPLIANCE .....................................................................iv
1. RECOMMENDED FUSING ............................................................................ 1
2. INSTALLATION .............................................................................................. 2
2.1 Mounting Considerations ...................................................................... 2
2.2 Mounting Dimensions for Single Module Controllers ............................ 3
2.3 Mounting Dimensions for Two Module Controllers ............................... 4
2.4 Remote Display Kit ............................................................................... 5
2.4.1 Mounting Considerations ........................................................... 5
2.4.2 Mounting Instructions ................................................................. 6
3. WIRING .......................................................................................................... 8
3.1 Torque Specifications ............................................................................ 8
3.2 Universal Input Power........................................................................... 9
3.3 AC Cable Entry Heights / Wire Acceptance ........................................ 10
3.4 Line / Load Connections ..................................................................... 11
3.4.1 Single Phase ............................................................................ 11
3.4.2 Single Phase, Two Zone .......................................................... 12
3.4.3 Single Phase, Three Zone .......................................................13
3.4.4 Single Phase, Four Zone ......................................................... 14
3.4.5 Single Phase with Pass-Through ............................................. 15
3.4.6 Single Phase Two Zone with Pass-Through ............................ 16
3.4.7 Three Phase - Two Leg ............................................................ 17
3.4.8 Three Phase - Two Leg, with Pass-Through ............................ 18
3.4.9 Three Phase Three Leg - Delta or Three Wire Wye ................ 19
3.4.10 Three Phase Three Leg - Inside Delta ................................... 20
3.4.11 Three Phase, Three Leg - Four Wire Wye ............................. 21
3.5 Connectors ......................................................................................... 22
3.5.1 P1-12 Pin Command Connector .............................................. 22
3.5.2 External Feedback ................................................................... 23
3.5.3 SYNC-GUARD™ ..................................................................... 23
3.5.4 P2 - 6 Pin Relay Connector ..................................................... 24
3.5.5 P3 - 10 Pin Auxiliary I/O Connector ......................................... 24
3.5.6 P4 - Remote Display Connector .............................................. 24
4. AUX I/O Card (Optional) ............................................................................... 25
4.1 P3 - 10 Pin Aux I/O Connector............................................................ 25
APPENDIX A: Changing from Inside Delta to Delta or 3-Wire Wye Load ........ 26
APPENDIX B: Changing from 4 Wire Wye to Delta or 3-Wire Wye Load ........ 27
APPENDIX C: Fuse Replacement.................................................................... 28
To Next Page
Loading...