ControlFreq QUICK-FIT - Page 15

QUICK‐FITGSM
INSTALLATIONMANUAL

Page15
♦ Remote programming by SMS
;IN1=0;IN2=4;ID1=10;ID2=0;DD1=0;DD2=15;
9.1.2 REMOTE REPORTING ALARM EVENTS
Parameters used to define the way to report the alarm event.
NOTE
QUICK-FIT GSM device send SMS messages for reporting alarm events.
9.1.2.1 TN parameter
Telephone numbers for remote alarm reporting are listed as TN parameters. Remote
alarm reporting on QUICK-FIT GSM is done via SMS messages.
9.1.2.2 LN parameter
This parameter is used to link alarm event from inputs or any other source to the
telephone numbers from TN list.
9.1.2.3 LOT parameter
LOT parameter is used to define the time control for voice calls. The start of voice
connection starts the LOT timer. If the voice connection is still ON when the LOT timer
expires QUICK-FIT GSM disconnects voice connection.
9.1.2.4 Table of parameters
Name Comment
TN1 1
st
telephone number
TN2 2
nd
telephone number
TN3 3
rd
telephone number
TN4 4
th
telephone number
TN5 5
th
telephone number
LN1 Input & telephone No. linking for 1
st
alarm input (TN1 –
TN5)
LN2 Input & telephone No. linking for 2
nd
alarm input (TN1 –
TN5)
LN3 Input & telephone No. linking for 3
nd
alarm input (TN1 –
TN5)
LN4 Input & telephone No. linking for 3
nd
alarm input (TN1 –
TN5)
LN5 Periodic test SMS. No. linking (TN1 – TN5)
LN6 SIM card refill. No. linking (TN1 – TN5)