Controls 58-C0181/DGT User Manual

Manuale di Istruzioni
Instruction Manual
58-C0181/DGT Rev. 2 EN 04/02/2015
17
3.1 Charging the batteries
Connect the supplied cable to the socket of the charger and the USB port located on the
side panel of the instrument. To recharge the batteries, use only the charger provided with
the equipment. Plug the charger into an electrical outlet having the characteristics
described in chapter 2.6.
Fig. 3-1
The charger is constituted by a multi-stage transformer with USB connection to connect
to the cable provided and from 5 interchangeable plugs.
The charging cycle is optimized if performed with the instrument off. During charging
the red LED next to the USB port will remain on. Normally the charge takes about 4
hours.
Charge the battery when the ambient temperature is between 10 ° C and 40 ° C.
The battery status is shown in the upper right of the screen.
Fig. 3-2

Controls 58-C0181/DGT Specifications

General

Brand	Controls
Model	58-C0181/DGT
Category	Laboratory Equipment
Language	English