Controls 58-C0181/DGT - PC Connection; Installing the Program

Manuale di Istruzione
Instruction Manual
04/02/2015 58-C0181/DGT Rev. 2 EN
38
3.4 PC connection
The instrument is supplied with the software program C0181/DGT Manager that allows
to acquire and display the test data gathered during the measurements.
3.4.1 Installing the program
Here are the computer requirements to properly run the software:
• Microprocessor: AMD/Intel (1.6Ghz or higher)
• Operating system: Microsoft Windows XP, 7, 8, 32 or 64 bit
• RAM memory: 500Mb or higher
• Hard drive: at least 300Mb of free space
• CD drive
To install the program:
1. Load the CD into the drive of the PC.
2. In case the installation does nota start automatically, run the file SETUP on the CD;
next screen will be shown.
Fig. 3-40
3. Press OK to proceed.
Fig. 3-41