Manuale di Istruzione
Instruction Manual
04/02/2015 58-C0181/DGT Rev. 2 EN
48
4.2.2 ANVIL CHECK menu
Allows checking the proper calculation of the rebound index referred to the value of a
calibration anvil (normally 81).
Fig. 4-3
This test includes 5 preliminary strokes and 5 verification strokes. The display will show
the number of strokes still to be carried out and, for those of the verification phase, the
resulting rebound index. At the end the display will show the result of the test.
Fig. 4-4
Fit the instrument rod into the calibration anvil to take the measurements.
Fig. 4-5
To Next Page
Loading...
