Convotherm OEB 10.10 Installation Manual

Connecting up the combi steamer
Installation manual 53
Waste water temperature
The average temperature of the waste water from the combi steamer is 80°C. In order to reduce the
amount of escaping steam, the temperature of the waste water can be adjusted locally to 68°C mini-
mum in the Service level.
Service values for the waste-water temperature setting with standard controls
The waste-water temperature can be adjusted to the following values:
Service
item
Description Minimum temperature [°C] Maximum temperature [°C]
c02
Condenser temperature 68 80
Service values for the waste-water temperature setting with easyTOUCH controls
The waste-water temperature can be adjusted to the following values:
ID Description Minimum temperature [°C] Maximum temperature [°C]
8
Condenser temperature 68 80
Adjusting the waste-water temperature
To adjust the waste-water temperature of the combi steamer, follow the steps below:
Step Action More on this ...
1
Go to the Service level. Making settings in the Service level
on page 54
Fitting the drain connection
Follow the steps below to provide the water supply to your combi steamer:
Step Action
1
Connect the appliance as shown in the connection diagram.
2
If required, adjust the waste water temperature to 68°C.
3
Use cable ties to fix the high-temperature plastic pipe to the 3 hooks in the base flap.

Convotherm OEB 10.10 Specifications

General

Model	OEB 10.10
Capacity	10 x 1/1 GN
Power Supply	Electric
Cooking Modes	Convection, Steam, Combination
Voltage	400 V
Frequency	50/60 Hz
Temperature Range	30°C to 300°C