Copley Controls Xenus Plus Series - Page 156

Xenus Plus User Guide 16-01344 Rev 06
Copley Controls 156
D.2.6: Diagram: Edge Filter Wiring with Brushless Motor
This is an example for a Xenus Plus Single Axis drive. For Xenus Plus Dual Axis, connectors J3 or
J4 on the drive are used for outputs to the filter.
D.2.7: Diagram: Edge Filter Wiring with Brush Motor
This is an example for a Xenus Plus Single Axis drive. For Xenus Plus Dual Axis, connectors J3 or
J4 on the drive are used for outputs to the filter.
D.2.8: XTL-FA-01 Edge Filter Ordering
Filter
Model
Description
XTL-FA-01
Xenus Plus Edge Filter
Connector Kit
Model
Qty
Ref
Description
Mfr. Model No.
XTL-FK
1
J1
Plug, 5 position, 5.0 mm, female
Wago: 721-105/026-047
1
J2
Plug, 4 position, 5.0 mm, female
Wago: 721-104/026-047
2
--
Insertion / Extraction Tool
Wago: 231-131