cormidi Dumper - Blocking the Arm

General Information
7
1.6.2 Blocking the Arm
fig. 3 – blocking the arm
If necessary, the machine is equipped with a device used to block the down-
loading arm in the raised position and prevents accidental lowering, as needed
can be placed on the piston on the left or right in a similar manner.
Follow these steps (see fig. 3):
 Raise your arm of self-loading;
 Lift the body;
 Turn off the engine;
 Remove the safety device "B", on the left side of the skip, ;
 remove it by unscrewing the knob
 Insert the slots "A" of the bar close to the hydraulic cylinder;
 Turn the bar is parallel to the cylinder;
 Insert the pin "C"
 Pull down slowly with the engine off the skip until the interlocking device
After the operations, remove the device and place it back into place.
AC-ACW
HIAC-HIACW