cormidi Dumper - Connecting the Starter Cables; Starting the Engine; Disconnecting the Starter Cables

Instruction for use
39
3.12.2 Connecting the starter cables
1. Set the start switches on both machines to OFF.
2. Connect the clip of the red starter cable (A) to
the positive terminal of the battery on the machine
that has broken down.
3. Connect the other clip of the red starter cable
(A) to the positive terminal of the battery on the
repair machine.
4. Connect the clip of the black starter cable (B) to
the negative terminal of the battery on the repair-
ing machine.
5. Connect the other clip of the black starter cable (B) to the engine block of the
machine that has broken down.
3.12.3 Starting the engine
1. Check that the cables are connected safely to the battery terminals.
2. Start the engine on the repair machine and increase the engine speed to max.
3. Turn the starter switch of the machine that has broken down to START to start
the engine. If the engine does not start, wait at least two minutes before trying
again. Do not stop the engine on the repair machine and keep the engine speed at
full rate.
3.12.4 Disconnecting the starter cables
• After starting the engine on the machine that has broken down, disconnect the
starter cables in reverse order to the connection procedure.
1. Remove the clip of the black starter cable
(B) from the engine block of the machine that
has broken down.
2. Remove the clip of the black starter cable
(B) from the negative terminal of the battery on
the repairing machine.
3. Remove the clip of the red starter cable (A)
from the positive terminal of the battery on the
repairing machine.
4. Remove the clip of the red starter cable (A)
from the positive terminal of the battery on ma-
chine that has broken down.