Instruction for use
40
3.12.5 Charging the battery
• Remove the cables from the positive and negative terminals of the battery be-
fore setting the battery to charge. Otherwise, abnormal voltage may be applied to
the alternator and may damage it.
• When the battery is charging, remove all the plugs to release the gases
generated.
• If the battery overheats (the electrolyte temperature exceeds 45°C), stop the
operation.
• Stop the charging operation as soon as the battery is charged. If you continue,
the following faults may occur :
– battery overload
– reduction in the battery electrolyte
– battery failure
• Do not connect the connection cables to the terminals in reverse polarity. For
example, never connect the negative terminal on one machine to the positive
terminal on the other machine. A polarity reversal may damage the alternator.
• The battery must only be handled once the cables have been disconnected
(except for checking the level of electrolyte and the specified electrolyte density
measurement).
3.13 TRANSPORT
WARNING: During transport, always position the machine levelly to avoid
the spilling of oil or other liquids
If the machine needs to be transported, one
must proceed correctly to avoid dangers to
persons and/or to the machine, if there is
any on the machine, keep down completely
the bucket during the transport. Because of
the weight of the machine, it is not possible
to move it manually. Thus, it is necessary to
fig. 26 – Anchoring point
To Next Page
Loading...
