cormidi Dumper - 3.16 Storage

Instruction for use
44
-Place correctly the hooks on the stowing points.
-Check the condition of the trailer desk. If the deck is greasy, it should be cleaned
before to install the machine on the trailer.
-If the trailer deck is in steel, use a nonslip mat or blocks to prevent the tracks of
the machine to slip.
-Check the LC¹ of the stowing points on the trailer it must be at least equal to the
recommended LC¹ of the stowing accessories.
-Check the location and the condition of the stowing points on the machine.
-Stow the machine at the points provided for the purpose and that are indicated
on the machine. Cormidi recommends to stow the machine the direct stowing di-
agonally method and to respect the following angles according to" between "the
machine" and "the direct"
Be careful to the sliding of the stowing accessories, it does not stand on sharp
edges or present knot during the stowing.
-Make sure to correctly balance the load on each stowing points and to do not
overload them.
3.16 STORAGE
Whenever the machine must remain inactive for several months, it is necessary to
provide a correct garaging so that the machine is in perfect working order when it
is used again. In particular one must carry out storage by following all of these in-
structions:
 Carry out all necessary repairs;
 Disconnect the battery, turning the device to cut off battery;
 Empty the fuel tank completely;
 Proceed with a careful cleaning and remove all mud, and/or organic residues
carefully;
 Proceed with all operations regarding the motor that are described in its own
manual;
 Carry out a greasing of all points listed in the specific chapter;
 Place the machine in such a way that it is sheltered from atmospheric agents
under stable conditions and on a flat surface;
 If the machine is equipped with batteries, unplug them and lubricate with the
¹LC= Lashing capacity