corob PROsample 200 - Troubleshooting

- 35 -
COROB D200
6.6 
  
Themachinedoesnotturnon.
Powersupplyismissing.
Checktheconneconsatthebackofthemachine
(chapter5.5).
MainswitchinOFFposion(O).
SetthemainswitchtotheONposion(I)(chapter
5.5).
Oneormorefusesmaybeblown
up.
Replaceanyblownfuseinsidethefusecompartment
(chapter5.4).
Thepowersupplyunitisin
overcurrent.
Waitafewminutesandtrytorestartthemachine.If
theproblempersists,contacttheauthorizedtechnical
service.
Electricalconneconsaredefecve. Contacttheauthorizedtechnicalservice.
Themanagementsoware
showsanerrorinthe
communicaonprotocol.
MachineisOFF.
Turnthemachineon(chapter5.5)andrestartthe
managementsoware.
Machinedisconnectedfromthe
computer.
Checktheconneconsatthebackofthemachine
(chapter5.5).
Computer serial port or USB port
wronglyconguredordefecve.
Usetheconguraonandcalibraonsowareto
makesureyouhavecorrectlyconguredtheportused
tocommunicatewiththemachine.
RepairthecomputerserialportorUSBport.
Serialcabledamaged.
Replacethecommunicaoncableusing
manufacturer’soriginalspareparts.
Connecondefecve. Contacttheauthorizedtechnicalservice.
Colorantdrippingfromsome
nozzles.
Thevalveofthepumpingunitdoes
notworkcorrectly.
Fromthemanagementsowaredispenseapprox.
100ccofcolorantfromthepumpingunitinvolved
(chapter6.3).Iftheprobleminvolvesmanycircuits,
repeattheaboveoperaonforonecircuitatame,
soastorecyclethecolorantdispensed.
Iftheproblempersists,contacttheauthorized
technicalservice.
Ifpresent,theONlampblinks
slowlyandthemachinerefuses
thecommands.
Themachineisintheo-line1
condion.
Bringthemachinetotheon-linecondionbyusing
theo-linebuonorbysendingaResetcommand
(chapter5.7).
Ifpresent,theONlampblinks
fastandthemachinerefusesthe
commands.
TheAutocapisopenandthe
machineisintheo-line2
condion.
ClosetheAutocapandbringthemachinetotheon-
linecondionbyusingtheo-linebuon(chapter
5.7).