13
Page
WORKSHOP
MANUAL
We reserve the right to modify the product and the design.
- After you have removed them, replace all sealing/adjusting shim
washers (1) and counter dowels. Bend the locking edges, adjusting
them to the at surfaces of the screw or nut after tightening it to the
specied torque.
- Install bearings and seals in such a way that the manufacturer’s
brands are visible. When assembling them, apply a thin layer of
lightweight lithium soap-based grease to their lips. Apply oil in
abundance when installing bearings.
- When you install bearings and seals make sure that you exert an
even pressure on both tracks so as not to damage them.
- During the installation, always use new gaskets, seals, piston
compression rings and latches.
- After disassembly, clean the components with non-ammable
solvent or one with a low ammability point.
Lubricate all working surfaces before installation, excluding the
conical couplings.
- After assembly, check that all components have been installed
correctly and that they work perfectly.
- For disassembly, inspection and installation operations, only use
tools with metric measurements. Metric screws, nuts and bolts are not
interchangeable with connecting parts with English measurements.
The use of unsuitable tools and connecting parts may damage your
vehicle.
- In the case of interventions on the electrical installation of the
vehicle, check that the electrical connections have been installed
correctly, especially the ground connections.
“WORK METHODOLOGY” RECOMMENDATIONS
To Next Page
