CORVUS TERRAIN DX4 PRO - Brake Fluid Change

72
Page
WORKSHOP
MANUAL
We reserve the right to modify the product and the design.
MAINTENANCE
BRAKE FLUID (CHANGE)
The brake uid reservoir is located under the front hood.
1. Place the vehicle in a completely horizontal position.
2. Loosen the four screws to remove the cover.
3. Unscrew the cap from the reservoir (1) in an anticlockwise direction and wait a few
seconds until the vapours disperse.
4. Remove the rubber cap from the bleed screw (2) and attach a rubber tube to collect the
liquid.
5. Keeping your foot on the brake pedal, loosen the bleed screw (3) so that the air in the
installation can get out.
6. Repeat the operation until only new brake uid oozes from the rubber tube, beforehand,
gradually ll the brake uid reservoir with new uid.
7. Tighten the bleed screw.
8. Restore the brake uid level in the reservoir.
9. Perform this operation for the four brake callipers.
10. If necessary, purging is also possible using a specic vacuum pump. Contact your
Corvus Technical Service.
TECHNICAL INFORMATION
Recommended uid: DOT-4 brake uid.
Tightening torque of the brake caliper bleed screws. 7-9 Nm.
1
2
3