74
Page
WORKSHOP
MANUAL
We reserve the right to modify the product and the design.
MAINTENANCE
BRAKE PADS (CHECK)
If the thickness of any of the front or rear disc brake pads is less than
1.5 mm, completely change the set of affected pads.
DANGER
VERIFY THAT THE DISC THICKNESS IS AT LEAST
3.5 MM IN THE FRONT AXLE AND 3.5 MM IN THE
REAR AXLE.
WARNING
WE RECOMMEND THAT YOU GO TO YOUR CORVUS
DEALER TO CHANGE THE BRAKE PADS. THEY WILL
ALSO CHECK FOR ANY POSSIBLE WEAR OF THE
BRAKE DISCS.
WARNING
ONCE YOU HAVE INSTALLED THE NEW PADS, IT IS
PROBABLE THAT THE BRAKE FLUID LEVEL WILL HAVE
RISEN; CHECK THE LEVEL.
TECHNICAL INFORMATION
Wear limit:
1.5 mm.
Wheel nuts
tightening torque: 60 Nm
Clamp screws tightening torque:
30 Nm
To Next Page
Loading...