66
Page
WORKSHOP
MANUAL
We reserve the right to modify the product and the design.
MAINTENANCE
SLIDING PULLEY - MAINTENANCE
Recommended inspections
The cam shoes must be replaced if they show wear of up to approximately
1 mm before making contact with the aluminium ange.
After you remove the screws with a Torx No. 20 screwdriver, the cam
shoes can be removed with a at-ended screwdriver.
Assemble the friction bushing
with the help of a hammer
WARNING
TAP THE FRICTION BUSHINGS GENTLY (4) SO
AS NOT TO DAMAGE THEM.
ALWAYS CHANGE THE THREE FRICTION BUSHINGS (4)
AT THE SAME TIME.
APPLY A FASTENING TORQUE OF 2.5 TO 4.5 NM.
4
To Next Page
