CORVUS TERRAIN DX4 PRO - Safety Regulations; Maintenance Standards

38
Page
WORKSHOP
MANUAL
We reserve the right to modify the product and the design.
SAFETY REGULATIONS MAINTENANCE STANDARDS
DANGER
- Were it to be necessary to keep the engine running to
carry out an intervention on the vehicle, make sure that
the work environment is well ventilated and, if necessary,
use adequate air extractors; never run an engine in closed
premises. The exhaust gases that are produced are toxic.
- The battery electrolyte contains sulphuric acid. Protect
your eyes, clothing and skin. Sulphuric acid is highly
corrosive; in case of contact with eyes or skin, wash with
plenty of water and go to a doctor immediately.
- Batteries produce hydrogen, a gas that can be highly
explosive. Do not smoke and avoid open ames or sparks
near the battery, especially when you are charging it.
- Gasoline is extremely ammable and can explode under
certain conditions. Do not smoke and do not allow any
open ames or sparks in the work area.
- Clean the brake pads in a ventilated place, directing
the jet of compressed air in such a way that you do not
breathe in the dust produced by the wear and tear of the
friction material. Although such dust does not contain
asbestos, inhalation is nevertheless harmful.
DANGER
- Use original CORVUS spare parts and lubricants
recommended by CORVUS. Non-original or non-
compliant spare parts can damage the vehicle.
- Only use tools designed specically for this vehicle.
- Always use new gaskets, sealing rings and pins during
assembly.
- After disassembly, clean the components with non-
ammable solvent or one with a low ammability point.
Lubricate all working surfaces before assembly, excluding
the conical couplings.
- After assembly, check that all components have been
installed correctly and that they work perfectly.
- For disassembly, inspection and assembly operations,
only use tools with metric measurements. Metric screws,
nuts and bolts are not interchangeable with connecting
parts with English measurements. The use of unsuitable
tools and connecting parts may damage your vehicle.