50
Page
WORKSHOP
MANUAL
We reserve the right to modify the product and the design.
MAINTENANCE
5. Turn the nut of the socket (3) counterclockwise to loosen it.
6. Remove the socket very carefully, and empty its contents into a
container used to collect pollutants.
7. Clean the inside of the socket with clean fuel.
8. Inspect and clean the mesh of the lter (5). If it is worn out, replace
it with a new one.
9. Check the condition of the O-ring (4) and replace it if it is worn out.
10. Reinstall the socket, introducing the O-ring (4) and tightening the
fastening nut manually (3).
11. Open the fuel stopcock (6) to the O position.
12. Check the tightness of the installation.
6
4
3
5
To Next Page
Loading...