Standards and IEC Classifications
3-10 Force FX Electrosurgical Generator C Service Manual
Voltage Transients (Emergency Generator Mains Transfer)
The Force FX Electrosurgical Generator C operates in a safe manner when the transfer is
made between line AC and an emergency generator voltage source.
The Force FX Electrosurgical Generator C intentionally applies RF energy for diagnosis or
treatment during activation. Observe other electronic medical equipment in the vicinity during the
Force FX Electrosurgical Generator C activation for any possible adverse electromagnetic effects.
Ensure adequate separation of electronic medical equipment based on observed reactions.
The use of accessories, other than those specified in the Force FX Electrosurgical Generator C User
Guide and Service Manual, may result in increased emissions or decreased immunity of the Force
FX Electrosurgical Generator C.
Guidance and manufacturer's declaration - electromagnetic emissions
The Force FX
Electrosurgical Generator C is intended for use in the electromagnetic environment
specified below. The customer or the user of the Force FX Electrosurgical Generator C should
ensure that it is used in such an environment.
Emissions test Compliance Electromagnetic
environment - guidance
RF emissions
CISPR 11
Group 1 The Force FX Electrosurgical
Generator C uses RF energy
only for its internal function.
Therefore, its RF emissions are
very low and are not likely to
cause any interference in
nearby electronic equipment.
RF emissions
CISPR 11
Class B The Force FX Electrosurgical
Generator C is suitable for use
in all establishments other
than domestic and those
directly connected to the
public low-voltage power
supply network that supplies
buildings used for domestic
purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations/ flicker
emissions IEC61000-3-3
Complies
Notice
To Next Page
Loading...
