24 • Indoor Relative Humidity Sensor (P/N 203-5750) 026-1701 Rev 0 01-05-98
Software Setup
Input Board and Point Configuration
Set up the relative humidity sensor by assigning the
board and point address to the appropriate input. Refer to
the REFLECS Installation and Operation Manual for more
information.
Sensor Control Setup
If the relative humidity sensor is being set up in Sensor
Control, the Sensor type must be defined as (H)um in the
Sensor Setup screen. Refer to the REFLECS Installation
and Operation Manual for more information.
Figure 20 - Relative Humidity Sensor Wiring
To Next Page
Loading...