CPC 485 - Software Requirements for Eclipse Pressure Transducers

Peripherals Manual Eclipse Pressure Transducers • 35
4. On switch S1 or S2 on the 16AI, set the rock-
er corresponding to the input number to the
DOWN position.
Software Requirements for
Eclipse

Pressure Transducers
CPC supplies Eclipse pressure transducers with all new
refrigeration control orders. If using RMCC v. 2.10 or
above, the controller will by default read Eclipse transduc-
ers; no additional setup is required.
All versions of the RMC software after and including v.
6.08 and all versions of the RMCC software may be con-
figured to accept input from either a standard or Eclipse
transducer. Users may set transducer types from the front
panel in all versions EXCEPT RMCC 2.00, 2.01, 2.02,
2.03, and 2.04 – these versions require UltraSite to set up
Eclipse transducer compatibility.
To choose Eclipse or Standard transducer type from the
front panel:
1. Enter the transducer’s board and point ad-
dress in the Input Definitions screen.
2. From the main menu, choose the Configura-
tion option, followed by the Xducer Types
option. Your screen should appear similar to
the following:
3. Using the DOWN and UP arrow keys,
scroll through the Pressure Transducer Type
screens until the desired transducer is shown.
The Pressure Transducer Type screen is
shown below.
4. Press the RIGHT arrow key, and then use
the arrow keys to move the cursor on to the
transducer’s Type field.
5. Select the desired type (either ECLIPSE or
STANDRD).
To choose Eclipse or Standard transducers using Ultra-
Site (v. 2.00 - 2.04), contact CPC for assistance. All other
REFLECS controllers use standard pressure transducers.
See “Standard Pressure Transducers,” page 37.
Figure 26-Typical Wiring Scheme for the Eclipse

Pressure
Transducer
26507004
INPUT CONNECTIONS
POWER
CONNECTIONS
5V
5V
5V
5V
12V
12V
12V
12V
ECLIPSE
16AI BOARD
SHIELD (BARE) WIRE
(TO ODD #)
BLACK (TO ODD #)
WHITE (TO EVEN #)
RED (TO 5V)
23456781
ON
23456781
ON
6
6