Note: The PF and Q value can be adjusted by remote software if the
“Remote” setting is selected.
1. PFSetValue：Set the PF value. This function changes the reactive
power by adjusting the Power Factor.
2. PFpCurve functions：PFp curve mode. Using the curves to set
the PFp setpoints (See Figure 6-16).
Figure 6-16 PF(P) Curve Mode
3. Q(U) Curve：Q(U) curve mode. Using the curves to set the reactive
power setpoints (See Figure 6-17). The reactive power
compensation changes according to the grid voltage.
To Next Page
Loading...
