Crestron DGE-100 User Manual

74 • DGE-100 and DM-DGE-200-C Product Manual — Doc. 7696D
o
Encrypt and Validate:The control system username and password will be required
to validate an encrypted SSL connection. Enter a username and password in the
appropriate fields that are displayed.
o
Encrypt:An encrypted SSLconnection will be used without requiring the control
system username or password for validation.
o
OFF:An SSLconnection will not be used.
l
Control System Username:If Encrypt and Validate is selected for SSLMode, enter the
control system admin account username.
l
Control System Password:If Encrypt and Validate is selected for SSLMode, enter the
control system admin account password.
l
Confirm Password:If Encrypt and Validate is selected for SSLMode, reenter the password
used for Control System Password.
l
Room ID:Enter the room IDthat is associated with the DGE. This setting is applicable only
if connecting the DGEto a Creston Virtual Control server-based control system.
NOTE:For more information on connecting the DGEto Crestron Virtual Control via a
room ID, refer to the Crestron Virtual Control Server Software ProductManual.
l
IPID:Enter the IPIDused to connect the DGEto the control system.
l
IPAddress/Hostname:Enter the IPaddress or host name of the control system.
l
Status:Reports the status of the connected control system (ONLINEor OFFLINE).
Select Save Changes next to the Control System accordion to save any changes. Select Revert to
revert to the last saved settings.
Configure Date/Time
Expand the Configure Date/Time accordion to configure the date and time settings for the DGE.
l
Enable Time Synchronization: Turn on the toggle to turn on time synchronization via SNTP
(simple network time protocol).
l
Time Server:If Enable Time Synchronization is turned on, enter the SNTPserver used to
synchronize the date and time for the DGE.

Crestron DGE-100 Specifications

General

Brand	Crestron
Model	DGE-100
Category	Engine
Language	English