Crestron DGE-100 User Manual

Product Manual — Doc. 7696D DGE-100 and DM-DGE-200-C • 75
l
Synchronize Now:If Enable Time Synchronization is turned on, select Synchronize Now to
synchronize the DGEwith the SNTPserver entered for Time Server.
l
Time Zone:Select a time zone for the DGEusing the drop-down menu.
l
Time(24hr format):Set the time for the DGE(in 24-hour format)using the pop-up menu
that is displayed.
l
Date:Set the date for the DGEusing the pop-up calendar that is displayed.
Select Save Changes next to the Configure Date/Time accordion to save any changes. Select
Revert to revert to the last saved settings.
Authentication Management
Expand the Authentication Management accordion to configure authentication management
settings for the DGE, including adding users and groups and assigning access levels.
Turn on the Enable Authentication toggle to turn on authentication for the DGE.
When authentication is turned on, the web configuration interface prompts the user to enter a
new administrator username and password. After restarting the DGE, this username and
password must be entered to access the web configuration utility or to connect to the DGE
through Crestron Toolbox™ software. For more information, refer to Turn on Authentication on
page 37.
CAUTION: Do not lose the administrator username and password, as the DGE must be
restored to its factory default settings to reset the username and password.
Use the following Authentication Management settings to add, delete, and edit DGE users and
groups.

Crestron DGE-100 Specifications

General

Brand	Crestron
Model	DGE-100
Category	Engine
Language	English