Crow RUNNER 8/64

To Next Page

To Previous Page

Page 73

Option 3 Blind Dial - When the dialler makes a call it looks for dial tone before making the call. If no dial tone is

detected the panel hangs up and attempts another call. The panel will do this 3 times and if dial tone is still

not detected it will make the call anyway. If blind dial is on, the panel skips the dial tone detection and dials

4 seconds after looping the line (used where non standard or low level dial tone exists).

Option 4 Use Group Numbers for Contact ID Reporting - When sending an alarm using Contact ID, the panel

can send separate account codes to report the two areas or, use one account code (P62E1E Area A) and

use the group number to identify the two areas. Turning this option on sends one account with group

numbers.

Option 5 Stay On-line after Alarm report for Audio Listen-in - If this option is turned ON and the optional listen-

in board is fitted, the panel will send a command to the monitoring company in CID or SIA formats to tell

the receiver to stay on-line so the operator can listen to the site for any sign of an intruder.

Option 6 Spare -

Option 7 Use the Dial Pre-fix Number - If the Telephone number does not provide sufficient digits for dialling

purposes it is possible to program a dial pre-fix number (P175E8E). The pre-fix can be dialled before the

telephone number. Turning this option on dials the pre-fix first followed by the telephone number.

MAXIMUM DIAL RE-TRIES per TELEPHONE NUMBER

MAXIMUM DIAL RE-TRIES per TELEPHONE NUMBER - P184E 1-8E (Value 0-99)

The maximum dial re-tries is the number of times that the panel will dial a telephone number in an attempt to get kissed

-off.

DIALLER REPORTING OPTIONS “A”

DIALLER REPORTING OPTIONS “A” - P186E 1-8E

Option 1 - Report Mains Fail

Option 2 - Report Battery Low

Option 3 - Report Radio Battery Low

Option 4 - Report Line Fail

Option 5 - Report System Tamper

Option 6 - Report Keypad Tamper

Option 7 - Report Zone Tamper

Option 8 - Report Radio Zone Tamper

Option 1 Report Mains Fail - If this option is on the panel will report a Mains fail after the report delay time

(P25E6E) has expired.

Option 2 Report Battery Low - If this option is on the panel will report a Battery Low.

Option 3 Report Radio Battery Low - If this option is on the panel will report a Battery Low from any radio zones

that have the battery status monitored.

Option 4 Report Line Fail - If this option is on the panel will report a Telephone Line fail. The panel will send the

line fail and the line restore at the same time.

Option 5 Report System Tamper - If this option is on the panel will report a Tamper Alarm on the panel tamper

input.

Option 6 Report Keypad Tamper - If this option is on the panel will report a Tamper Alarm from a keypad fitted

with a tamper switch or a wrong code alarm from a keypad.

Option 7 Report Radio Zone Tamper - If this option is on the panel will report a Radio Zone Tamper Alarm.

Crow RUNNER 8/64 - Page 73