Crowcon Gas-Pro - Set-up; Prior to use

12
1. Set-up
1.1 Prior to use
Before use, the Gas-Pro should always be checked for any signs of physical damage.
Gas-Pro uses a Lithium Ion (Li-ion) battery pack and should arrive with sufcient charge to be used
straight out the box. However, if this is the rst time of use, you may need to charge the battery to
attain the full operating time (see Charging on page 13).
For battery run times, see the table on page 55.
i
The actual operating time will depend on the types of sensor installed.
1.2 Gas-Pro orientation
Figure 1: Gas-Pro
À D-ring à Sounder Æ Sensor apertures É Charging cable
Á Alarm bars Ä Operator button Ç Dual colour LCD display Certication label
 +ve Safety™ indicator Å Pump inlet/outlet* È Alligator clip
* Blanked for non-pumped unit.
À
Ç
Ã
É
È
Ä
Â
Å
Æ
Á
Contents
Exit
Prologue
Operation
Gas testing
Maintenance
PC software
Accessories
Specication
Troubleshooting
Appendices
Warranty
Set-up