Crowcon Gas-Pro - Flammable Pellistor Sensors

53
10.1.2 Flammable Pellistor Sensors
i
Flammable sensors MUST only be used with the PCB P/N as detailed below in the ‘PCB
P/N Suitability” Column. Failure to do so may impair intrinsic safety and invalidate safety
certication.
Gas Sensor Part No. Range PCB P/N Suitability
Methane SS0101 0-100% LEL S013021, S013022, S013024
Pentane SS0101 0-100% LEL S013021, S013022, S013024
Butane SS0101 0-100% LEL S013021, S013022, S013024
Ethylene SS0101 0-100% LEL S013021, S013022, S013024
Propane SS0101 0-100% LEL S013021, S013022, S013024
Acetylene SS0101 0-100% LEL S013021, S013022, S013024
Hydrogen SS0101 0-100% LEL S013021, S013022, S013024
10.1.3 Flammable IR Sensors
Gas Sensor Part No. Range
Methane* SS0201 0-100% LEL
Pentane* SS0201 0-100% LEL
Propane* SS0201 0-100% LEL
Butane* SS0201 0-100% LEL
* For Dual Range IR Gas-Pro & Tank Pro the same spare part number should be used as detailed above
10.1.4 Oxygen
Gas Sensor Part No. Range
O
2
SS0500 0-25% VOL (2 years)
O
2
SS0501 0-25% VOL (3 years)
10.1.5 IR
Gas Sensor Part No. Range
CO
2
SS0280 0-5% VOL
(2-5% for indication)
10.1.6 PID
Gas Sensor Part No. Range
PID SS0600 0 -1000ppm
Contents
Exit
Prologue
Operation
Gas testing
Maintenance
PC software
Accessories
Specication
Troubleshooting
Appendices
Warranty
Set-up