Figure 20: WiFi and Cellular Modem Connections
2.4.12 WIFI
The Vecto III can communicate via WIFI either as an access point or with existing
supported infrastructure access points (see Osprey Lite
TM
User Manual). Please
contact CT LAB for an updated list of supported WIFI routers.
Before enabling WIFI, first ensure that the WiFi antenna is
connected, as enabling WiFi without the antenna connected
may cause damage to the device.
2.4.13 Built-in GPRS Modem (Optional)
The Vecto III can be shipped with a built-in modem (see Figure 20). Please refer to the
Osprey Lite
TM
user manual for instructions on configuring modem communication.
Before enabling the modem, first ensure that the modem
antenna is connected, as enabling the modem without the
antenna connected may cause damage to the device.
2.5 Firmware
The Vecto III firmware revision is shown in Osprey Lite
TM
when connected to the
device, please see Osprey Lite
TM
user manual for more information.
2.5.1 Upgrading
The Vecto III support firmware upgrade via Osprey Lite
TM
, please see Osprey Lite
TM
user manual for more information.
To Next Page
Loading...
Need help?
General