CT Lab Vecto III - DIN rail mounting; Connections; AC Power

Vecto III User Manual
54
4.1.3 DIN rail mounting
Figure 25: Vecto III rear view as shipped by CT LAB
Unscrew the Allen-key screw shown in Figure 25 and turn the installation plates over
as indicated. The Din rail mounting is in a Vecto III cavity and will be available for use
when the installation plates are turn over as shown in Figure 26.
Figure 26: Vecto III rear view when Din rail mountings are to be used
4.2 Connections
4.2.1 AC Power
Always connect the safety earth terminal located on the power
connector first
Table 8 and Figure 27 depict how to connect the AC power supply.
1.
2.
1.
2.