In the unlikely event of permanent internal system corruption the device will not be
able to boot correctly. In this case, the Status LED will change directly from the orange
boot state to the red error state, and back to the flashing red state, until the device is
turned off by pressing the On/Off button. Please contact CT LAB for support if this state
is encountered and not cleared by switching the device to storage mode and back to
ready mode.
4 Vecto III Installation
4.1 Mounting the Vecto III
Please Note: Adequate ventilation must be provided to prevent building up of heat –
especially when the device are to be installed inside a sealed enclosure.
4.1.1 Panel Mounting Installation
Figure 22: Vecto III back as supplied by CT LAB
Unscrew the Allen-key screw shown in Figure 22 and turn the installation plates to the
outside and shift hole 1 to 2. This should leave the installer with surface mounting
holes, as indicated in Figure 23, to install the device on the required surface.
To Next Page
Loading...
Need help?
General