Curtiss-Wright DTS1 - Serv Command

User Guide DDOC0099-000-AH
DTS1 CSfC 12 - 43 Command Line Interface
© 2020 Curtiss-Wright Defense Solutions Revision 5.0
12.3.27 serv
NOTE
The DTS1 has only 1 RMC slot. As a result, the -s option is always -s 0.
Description
The serv command allows the user to set the boot configuration for DTS services and to manually
start/stop services. When no options are given, the current boot configuration and active status is
displayed for all the services.
Syntax
serv [-h | --help | --version]
serv [-a] [-n] [-w] [-h] [-f] [-d] [-t]
serv --boot [-a] [-n] [-w] [-h]
Options
-h, --help............................Print help message.
--version............................Print program version.
-B, --boot ............................. Apply the settings to the boot-time configuration.
-a, --all <num> ..................All Services
-c, --cifs <num> ..............CIFS Service
-n, --nfs <num>................NFS Service
-f, --ftp <num> ..................FTP Service
-w, --http <num> ...............HTTP Read Service
-d, --dhcp <num> ................DHCP Service
-t, --tftp <num>...............TFTP Service
-z, --tel <num> ..................Telnet Service
-s, --snmp <num> ................SNMP Service
Enumerated type:
<num> ....................................Selects server state. 0=Disable, 1=Enable, 2=Use boot setting
Example: Status/configuration display
Line Identifier
BOOTCFG .............................Reports of service states to be applied at boot-up.
LIVECFG................................Reports the current operation state of each service.
Fields
cifs=<s> ..............................Common Internet File System service state
nfs=<s>.................................Network File System service state
ftp=<s>.................................File Transfer Protocol service state
http=<s> ..............................Hypertext Transfer Protocol service state
dhcp=<s> ..............................Dynamic Host Configuration Protocol service state
tftp=<s> ..............................Trivial File Transfer Protocol service state
tel=<s>.................................Telnet service state
snmp=<s> ..............................Simple Network Management Protocol service state
status=<sts> .......................Summary status for the line
NOTE
The 'status' field appears on the same line as the others. The example output above is line
wrapped for clarity.
Enumerated types:
cw_dts> serv
[serv]
BOOTCFG: cifs=<s> nfs=<s> ftp=<s> http=<s> dhcp=<s> tftp=<s> tel=<s> snmp=<s>
status=<sts>
LIVECFG: cifs=<s> nfs=<s> ftp=<s> http=<s> dhcp=<s> tftp=<s> tel=<s> snmp=<s>
status=<sts>
[!serv] <summary>