20. If a different type of anti-freeze
is to be used, ll the cooling sys-
tem with clean water, run the en-
gine for approx. 5 minutes and
drain the water. Repeat this 2 to
3 times before adding new anti-
freeze.
Coolant
Capacity
1.7 U.S Gal. (6.3 L)
Water+Ethylene glycol
50:50
UUVo733A
9. Loosen the air bleeder bolt for
fast drain.
10. Disconnect the hose from the
bottom of the auxiliary coolant
tank to drain the coolant in it.
11. Flush the cooling system with
clean water 2 to 3 times as nec-
essary until clean water is pres-
ent.
12. Reconnect the hose to the auxil-
iary coolant tank.
(1) Air Bleeder Bolt
13. Make sure to install the drain
plugs for radiator and engine be-
fore lling new coolant.
14. Fill the tank with water and an-
ti-freeze (Ethylene glycol) in ratio
of 50:50.
15. F i l l s l o w l y t h e n e w c o o l a n t
through radiator ller with bleed-
ing air out from the air bleeder
bolt loosened.
16. Squeeze the coolant rubber hos-
es several time before tightening
the bleeder bolt to make sure no
air left in hoses.
17. Make sure every plugs and caps
for cooling by system is inplaced
rmly.
18. Test run the engine to find any
leakage.
19. The coolant mixture ratio may
differ by local climate. Therefore,
contact your Dealer for the cor-
rect mixture ratio.
To Next Page
Loading...
