Q3x BTH
DEVICE NAME AND
FIRMWARE MODULES
RELEASE
PRINTER SETUP
PRINTER TYPE .............................. <device model>
PRINTING HEAD TYPE.................. <head model>
INTERFACE .................................... BLUETOOTH
PROGRAM MEMORY TEST........... OK
STATIC RAM TEST......................... OK
EXTERNAL MEMORY TEST .......... OK
CUTTER TEST................................ OK
HEAD VOLTAGE [V] = 23.70
HEAD TEMPERATURE [°C] = 25
POWER ON COUNTER = 4
PAPER PRINTED [cm] = 40
CUT COUNTER = 1
BT PRINTER ID = <dispositivo_n. di serie>
PAIRING BT PIN = 1234
BT BUILD VERSION = 121016A IDPS
Wireless......................................... : ON
BT AutoReconnect......................... : Disabled
Pairing BT...................................... : Disabled
RS232 Baud Rate ......................... : 19200 bps
RS232 Data Length....................... : 8 bits/chr
RS232 Parity ................................. : None
RS232 Handshaking ..................... : Xon/Xoff
Busy Condition .............................. : RxFull
USB Address Number ................... : 0
USB Virtual COM........................... : Disabled
Autofeed ........................................ : CR Disabled
Print Mode ..................................... : Normal
Chars / inch ................................... : A=15 B=20 cpi
Speed / Quality.............................. : Normal
Black Marck Alignment .................. : Enabled
Black Marck Threshold .................. : 40%
Black Marck Distance [mm]........... : +15
PaperEnd Buffer Clear .................. : Disabled
Font Type....................................... : International
Code Table [num] .......................... : 00
USB Virtual COM........................... : Disabled
Print Density.................................. : 0%
[ PUSH ] key to enter setup
[ FAST PUSH ] key to skip setup
DEVICE
STATUS
KEYS FUNCTIONS
<device>
SCODE <code> - rel.
FCODE <code> - rel.
DEVICE
CONFIGURATION
PARAMETERS
41
To Next Page
Loading...
