6.5 Operating parameters
The parameters marked with the symbol
D
are the default values.
Settings remain active even after the device has been turned off and they are stored in non-volatile memory.
PRINT MODE Printing mode:
Normal
D
= enables printing in normal writing way
Reverse = enables printing rotated 180 degrees
AUTOFEED Setting of the Carriage Return character:
CR disabled
D
= carriage Return disabled
CR enabled = carriage Return enabled
Font selection:
A = 11 cpi, B = 15 cpi
A = 15 cpi, B = 20 cpi
D
NOTE: CPI = Characters Per Inch
Setting of printing speed and printing quality:
Normal
D
High Quality
PAPEREND BUFFER CLEAR Cleaning mode of the data in receive buffer, if the printing is stopped due to lack of paper:
Disabled
D
= the data remain in the receive buffer. When the paper runs out, the device
keeps the remaining data in the receive buffer and prints the remaining
portion of the ticket after that the new paper is loaded.
Enabled = when the paper runs out, all data in the receive buffer are deleted.
FONT TYPE Setting of the font type:
International
D
= Enables the use of the 256 characters font tables
Chinese GB18030 = Enables the use of the chinese extended font GB18030-2000
NOTE: When the “International” font is enabled, you need to choose the character
code table (parameter “Code Table”). When the Chinese or Korean fonts is enabled,
the selection of the character code table is suspended (parameter “Code Table”).
47
To Next Page
Loading...
