CODE TABLE [NUM]
setting of two digits for the tens and the units:
Code Table [num x 10] Setting the digit for tens:
0
D
2 4
1 3 5
Code Table [num x 1] Setting the digit for units:
0
D
2 4 6 8
1 3 5 7 9
NOTE:
See the
paragraph 10.7 to learn about the character tables corresponding to the
The character tables set with this parameter are the same set with the command 0x1B
0x74 (refer to the commands manual of the device).
PRINT DENSITY Adjusting the printing density:
-25% 0%
D
+25%
-12% +12%
48
To Next Page
Loading...
